JT Wave Soldering Machine
- Nitrogen Closed-loop Control: JT Wave Soldering Machine Real-time of nitrogen concentration, PID closed-loop adjust nitrogen flow to achieve the stable PPM value and save the nitrogen consumption
- Increase Solder Stability: By nitrogen protecting in order to improve the wetting of wave infiltration and enhance solder penetration rate to make sure the stability of quality.
- Reduce Solder Defect: The tunnel-based entire nitrogen wave soldering can reduce solder defect and improve production efficiency with less oxygen content.
- Save Cost: The closed preheating environment can reduce the power and the production of solder dross.
| Model NO | NXS-450 | |
| Parameters | Dimension(LxWxH) | 5635x1620x1735mm |
| Supply Power (3 phases 5 wires) | 3P5W380V AC,50/60Hz 160A or 3P5W220V AC,50/60Hz 130A | |
| Required Lnitial Power | 90KW | |
| Required Air Source Power | 0.5~0.8Mpa | |
| Total Power | 60KW | |
| Operating Power | 10-13KW | |
| Control Method | PC+PLC | |
| Air Sourse | 0.5-0.8Mpa | |
| Control System | PC +PLC | |
| Spray System | Flux Flow | 10~100ml/min |
| Spray Pressure | 0.25MPa-0.4MPa | |
| Preheating System | Preheating Method | Hot air/IR for option(module) |
| Speed Adjustment Mode | IR: Ni | |
| Quantity | 3 sections (4 sections for option) | |
| Length | 1950mm (3 segments); 2250mm (4 sections) | |
| Temp. Range | Room temperature – 280 ℃ | |
| Temp. Control Mode | PID+SSR | |
| Soldering System | Wave Peak Operation Mode | Mechanical pump |
| Power for Heating Tube | 1.5KW*12 | |
| Pot Capacity | Approx 550KG | |
| Ultimate Bearing Temperature | Max: 300 ℃ | |
| Ultimate Usage Temperature | Max: 280 ℃ | |
| Wave Peak Driven Power | 1/2 HPx2 AC 220V3Φ | |
| Height Adjustment Mode | Inverter adjustment | |
| Heating Time | 100 min 250℃ | |
| Wave Peak Select | Dual-wave: Spoiler + flat or Spoiler + Spoiler | |
| Wave Height | 0~15mm | |
| PCB Conveyor System | Conveying Speed | 0~1800mm/ min |
| Width Range of PCB | 50-450mm | |
| Length Range of PCB | 120-600mm | |
| Height of PCB Component | Top: 150mm Bottom: 25mm | |
| Conveyor Height | 750±20mm | |
| Angle of Rail | 5.5 fixed | |
| Motor Rotation Mode | Sectional transimmission/control | |
| Conveyor Motor Powe | 90W*3 3P 220V AC | |
| 40KG | ||
| Conveyor Mode | fragment conveyor: chain- fingers (V+L/full V/ full L) – chaiN | |
| Conveyor Motor Speed Adjustment | Inverter adjustment | |
| Gas Parameters | 30m³/h 1000ppm | |
| Nitrogen Source Pressure | 0.5-0.8MPa | |
| Nitrogen Source Oxygen Content | ≤10PPM | |
| No.of Nitrogen Flowmeter | 7 | |
| Others | Exhaust Fan | AC380V 750W |
| Diameter of Exhaust Duct | Φ200mm | |



Reviews
There are no reviews yet.